Stabilizator puternic de combustibil diesel

During the last few decades the need for increasing middle distillate supply has led to the increased use of unstable cracked components in diesel fuel. Cracked components are higher in olefin content and are more prone to oxidation by free radical reactions.

Trimite anchetă

Descriere

ZX-RF-13 has resulted in the introduction of oxidative stability specifications and the increased use of additive stabilisers to enable refineries to cost-effectively meet these specifications.

ZX-RF-13 is a powerful diesel fuel stabiliser developed to provide enhanced oxidatitive and thermal stability for both diesel fuels and heating oils. It can improve the storage and thermal stability of diesel fuels and heating oils leading to a reduction in sediment and gum formation.

ZX-RF-13 can allow refiners to cost-effectively meet specification requirements for fuel stability and has the additional benefits of:

- Stabilising the fuel to control sediment and gum

- Aiding colour stability

- Minimising fuel filter blocking

- Allowing refineries to maximise unstable blending streams into higher value finished products


Density (15 degree , g/ml)	0.94 - 0.97
	>= 62
Kinematic Viscosity (16 degree , mm2/s)	31

Can directly add ZX-RF-13 to the diesel oil and ensure it is evenly distributed. The power reconciliation effect is better for mass addition. Can use the metering pump to add ZX-RF-13 into the diesel distillation pipeline, or also into the heat exchanger, into the static mixer, to ensure the full mixture of the agent and diesel oil.

product-859-858

Treat-rates may vary depending on the base fuel and stability specification requirement, however ZX-RF-13 normally be used in the range of 50 - 200 ppmv. Please contact our sales representative for specific recommendations.

200L steel drum or package according customer's request

ZX-RF-13 should be stored in a cool and dry environment. Avoid the collision during the handling process.

It should be isolated from oxidants and acids. Its shelf life is 4 years if maintained out of contact with direct sunlight, rain and freezing. 1 year or less if exposed to direct sunlight, rain or freezing.

Max handing temperature is 65 degree . Do not contact with water before use and minimize contact with air. During the operation, wear rubber gloves, goggles and mask, touch the skin immediately with a lot of water or 3% boric acid solution rinse, coated with zinc oxide ointment, serious cases sent to the hospital for treatment.